The CO1224T is a 12/24 volt, 6-wire, system-monitored carbon monoxide detector with RealTest (R) Technology.

The CMF-300 Addressable Control Module provides FireLite intelligent control panels a circuit for Notification Appliances (horns, strobes, etc.). Addressability allows the CMF-300 to be activated through panel programming, on a select (zone or area of coverage) basis. LiteSpeed is a communication protocol developed by FireLite Engineering that greatly enhances the speed of communication between analog intelligent devices. Intelligent devices communicate in a grouped fashion. If one of the devices within the group has new information, the panel CPU stops the group poll and concentrates on single points. The net effect is response speed greater than five times that of other designs.

Features

• Built-in type identification automatically identifies these devices to the control panel.
• Internal circuitry powered directly by two-wire SLC loop. The CMF-300 module requires power (for horns, strobes, etc.).
• Integral LED blinks green each time a communication is received from the control panel and turns on steady red when activated.
• High noise immunity (EMF/RFI).
• The CMF-300 may be used to switch 24-volt NAC power.
• Wide viewing angle of LED.
• SEMS screws with clamping plates for wiring ease.
• Direct-dial entry of address: 01 159 for MS-9600 series panels, 01  99 on MS-9200UDLS and MS-9050UD.

Features

• Single unit is capable of 12 VDC or 24 VDC determined by the input voltage
• Unit dimensions: 4.48in. (11.38 cm) high x 2.84in. (7.21 cm) wide x 0.5in. (1.27 cm) deep
• Jumper selectable temporal 3 or continuous tone
• Horn frequency is 3100Hz
• Low current consumption
• Terminal blocks 12 AWG to 18 AWG
• Variety of mounting options for new construction and retrofit applications
• Synchronize with Gentex AVSM Series control module
• Faceplate available in red or off-white

Addressable Mini-Monitor Module, One Style B (Class B) Initiating Device Circuit for Monitoring N/O contact devices, does not include a polling LED

The MMF-301 monitor module can be installed in a single gang junction box directly behind the monitored unit. Its small size and light weight allow it to be installed without rigid mounting. The MMF-301 is intended for use in intelligent, two-wire systems where the individual address of each module is selected using rotary switches. It provides a two-wire initiating circuit for normally open contact fire alarm and security devices. This module can be used to replace an M301 module in existing systems.