The MMF-300 Monitor Module is intended for use in intelligent, two-wire systems, where the individual address of each module is selected using the built-in rotary switches. It provides either a two-wire or four-wire fault-tolerant Initiating Device Circuit (IDC) for normally-open-contact fire alarm and supervisory devices. The module has a panel-controlled LED indicator. The MMF-300(A) can be used to replace M300 modules in existing systems.

Features

• Built-in type identification automatically identifies this device as a monitor module to the control panel.
• Powered directly by two-wire SLC loop. No additional power required.
• High noise (EMF/RFI) immunity.
• SEMS screws with clamping plates for ease of wiring.
• Direct-dial entry of address: 01  159 on MS-9600 series panels, 01  99 on other compatible systems.
• LED flashes during normal operation and latches on steady to indicate alarm.

The CO1224T is a 12/24 volt, 6-wire, system-monitored carbon monoxide detector with RealTest (R) Technology.

The CMF-300 Addressable Control Module provides FireLite intelligent control panels a circuit for Notification Appliances (horns, strobes, etc.). Addressability allows the CMF-300 to be activated through panel programming, on a select (zone or area of coverage) basis. LiteSpeed is a communication protocol developed by FireLite Engineering that greatly enhances the speed of communication between analog intelligent devices. Intelligent devices communicate in a grouped fashion. If one of the devices within the group has new information, the panel CPU stops the group poll and concentrates on single points. The net effect is response speed greater than five times that of other designs.

Features

• Built-in type identification automatically identifies these devices to the control panel.
• Internal circuitry powered directly by two-wire SLC loop. The CMF-300 module requires power (for horns, strobes, etc.).
• Integral LED blinks green each time a communication is received from the control panel and turns on steady red when activated.
• High noise immunity (EMF/RFI).
• The CMF-300 may be used to switch 24-volt NAC power.
• Wide viewing angle of LED.
• SEMS screws with clamping plates for wiring ease.
• Direct-dial entry of address: 01 159 for MS-9600 series panels, 01  99 on MS-9200UDLS and MS-9050UD.

Features

• Single unit is capable of 12 VDC or 24 VDC determined by the input voltage
• Unit dimensions: 4.48in. (11.38 cm) high x 2.84in. (7.21 cm) wide x 0.5in. (1.27 cm) deep
• Jumper selectable temporal 3 or continuous tone
• Horn frequency is 3100Hz
• Low current consumption
• Terminal blocks 12 AWG to 18 AWG
• Variety of mounting options for new construction and retrofit applications
• Synchronize with Gentex AVSM Series control module
• Faceplate available in red or off-white