Home  >  FIRE  > (x)
|◀ 157 - 168 of 8901 ▶|
View:

The CO1224T is a 12/24 volt, 6-wire, system-monitored carbon monoxide detector with RealTest (R) Technology.

Item#:
CO1224T
You must be logged in to order this item. Log in here

The CMF-300 Addressable Control Module provides FireLite intelligent control panels a circuit for Notification Appliances (horns, strobes, etc.). Addressability allows the CMF-300 to be activated through panel programming, on a select (zone or area of coverage) basis. LiteSpeed is a communication protocol developed by FireLite Engineering that greatly enhances the speed of communication between analog intelligent devices. Intelligent devices communicate in a grouped fashion. If one of the devices within the group has new information, the panel CPU stops the group poll and concentrates on single points. The net effect is response speed greater than five times that of other designs.

Features

  • Built-in type identification automatically identifies these devices to the control panel.
  • Internal circuitry powered directly by two-wire SLC loop. The CMF-300 module requires power (for horns, strobes, etc.).
  • Integral LED blinks green each time a communication is received from the control panel and turns on steady red when activated.
  • High noise immunity (EMF/RFI).
  • The CMF-300 may be used to switch 24-volt NAC power.
  • Wide viewing angle of LED.
  • SEMS screws with clamping plates for wiring ease.
  • Direct-dial entry of address: 01 159 for MS-9600 series panels, 01  99 on MS-9200UDLS and MS-9050UD.

Item#:
CMF-300
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
  • Single device for CO and smoke detection that uses less wiring and fewer junction boxes
  • Compatible with a wide range of control panels with the use of the required i4 Interface Module.
  • Sends distinct smoke and CO signals to the panel
  • Sounds Temporal 3 for smoke and Temporal 4 for CO
  • Built-in 85dB sounder
  • LEDs display both CO and smoke status
  • External IR LED provides extended range sensitivity testing
  • Versatile mounting allows for wall or ceiling placement
  • Easily replaceable electrochemical CO cell with 10-year end-of-life timer that signals the panel and chirps to alert the homeowner
  • RealTest® enables functional test using canned CO
  • Drift compensation and smoothing algorithms provide false alarm immunity
  • Compatible with SENS-RDR sensitivity tester
  • Full agency compliance with UL 268 and UL 2075
Item#:
COSMO-4W
You must be logged in to order this item. Log in here
FEATURES
™ Supports 12V and 24V FACPs
™ Sole path cellular, IP, or dual-path communications
™ CAT-M1 cellular is 5G-ready
™ Supports Contact ID reporting format
™ Trouble event detection and reporting
™ Four programmable input/outputs
™ Alarm capture via phone line interface or standard alarm outputs
™ UL certified for usage in commercial applications
™ At-a-glance system status via front panel LEDs 
Item#:
BAT-FIRE-VZ
You must be logged in to order this item. Log in here

The GHLF Series is a low profile, low frequency audible appliance that offers a 520 Hz square wave audible alarm with the most efficient (dBA to mA ratio) current draw available.

The GHLF Series produces a temporal 3 tone with a jumper selection for normal or loud decible tone. Listed to ANSI/UL 464, CAN/ULC, applicable IBC/IFC/IRC Standards and NFPA 72.

Features

  • Lower installation and operating costs
  • Nominal voltage 24VDC
  • Features SuperSlide® bracket  ease of supervision testing
  • Features Checkmate®  instant voltage verification
  • Synchronize horn with Gentex GTSM control module
  • Prewire entire system, install mounting bracket, then instsall signals
  • Input terminals 12 to 18 AWG
  • Produces a 520Hz square wave, temporal 3 tone
  • Jumper selection for normal or loud dBA
  • Temporal 4 pattern available when used with Gentex GTSM control module
  • Tamperproof re-entrant grill and locking screw
  • Faceplate available in red or off-white

Item#:
GHLFW
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here

  • Field selectable 12VDC or 24VDC operation
  • Jumper selectable temporal 3 or continuous tone
  • Horn frequency is 3100Hz
  • Terminal Blocks (12AWG to 18AWG)
  • Synchronize horn by using Gentex AVSM control module
  • Variety of mounting options for new construction and retrofit applications
Item#:
GX93-R
You must be logged in to order this item. Log in here
  • Single device for CO and smoke detection that uses less wiring and fewer junction boxes
  • Compatible with a wide range of control panels with the use of the required i4 Interface Module.
  • Sends distinct smoke and CO signals to the panel
  • Sounds Temporal 3 for smoke and Temporal 4 for CO
  • Built-in 85dB sounder
  • LEDs display both CO and smoke status
  • External IR LED provides extended range sensitivity testing
  • Versatile mounting allows for wall or ceiling placement
  • Easily replaceable electrochemical CO cell with 10-year end-of-life timer that signals the panel and chirps to alert the homeowner
  • RealTest® enables functional test using canned CO
  • Drift compensation and smoothing algorithms provide false alarm immunity
  • Compatible with SENS-RDR sensitivity tester
  • Full agency compliance with UL 268 and UL 2075
Item#:
COSMO-2W
You must be logged in to order this item. Log in here

The BG-12 series from Fire-Lite Alarms is a cost-effective, feature-packed, non-coded series of manual fire alarm pull stations. They offer a variety of different models including single- and dual-action versions. The BG-12 series were designed specifically for use in multiple applications and offer the flexibility to meet the needs of both the installer and end-user.

Item#:
BG-12L
You must be logged in to order this item. Log in here
|◀ 157 - 168 of 8901 ▶|
View:
(Denotes required field.)