Home  >  FIRE  > (x)
|◀ ◀ 217 - 228 of 7972 ▶ ▶|
View:

Connect FLX, Multi-Carrier, Z- Wave, Touchpad Pro

Item#:
CF-BASE-M
You must be logged in to order this item. Log in here

10-Input (Class B) or 5-Input (Class A) Monitor Module Card

Fire-Lite's MMF-300-10(A) ten-input monitor module provides an interface between the MS-9050UD, MS-9200UDLS, and MS-9600(UD)LS and normally open contact devices such as pull stations, security contacts or flow switches. Provisions are included for disabling a maximum of two unused addresses.

Features

  • Ten addressable Class B or five addressable Class A initiating device circuits.
  • Removable plug-in terminal blocks.
  • Status indicators for each point.
  • Unused addresses may be disabled.
  • Rotary address switches.
  • Class A or Class B operation.
  • Flexible mounting options.

Item#:
MMF-300-10
You must be logged in to order this item. Log in here

CLG HORN/STRB,WHT,FIRE White, FIRE Marking. Room Si

Item#:
EGCAVWF
You must be logged in to order this item. Log in here

AMPLIFIED SPEAKERS, 25 OR 70 V RMS, NEMA 3R, 24VDC RED

Item#:
AM-24R
You must be logged in to order this item. Log in here

100-PT REMOTE ANNUNCIATOR

The ANN-100 annunciator is a backlit, 80-character LCD fire annunciator that mimics the Fire Alarm Control Panel (FACP) display. It provides system status indicators for AC Power, Alarm, Trouble, Supervisory, and Alarm Silenced conditions. The ANN-100 and the FACP communicate over a two-wire serial interface employing the ANN-BUS communication format. Connected devices are powered, via two additional wires, by either the host FACP or a remote UL-listed, filtered power supply. ANN-100 is red.
  • Approved for use in Canada
  • Control switches for System Acknowledge, Signal Silence, Drill, and Reset
  • Control switches can be independently enabled or disabled at the FACP
  • Keyswitch enables/disables control switches and mechanically locks annunciator enclosure
  • Enclosure supervised for tamper
  • Local sounder can be enabled or disabled at the FACP
  • Displays device type identifiers, individual point alarm, trouble, supervisory, zone, and custom alpha labels
  • Surface mount directly to wall
  • Can be remotely located up to 6,000 feet (1,800 m) from the panel
  • Backlight turns off during AC loss to conserve battery power but will turn back on if an alarm condition occurs
Item#:
ANN-100
You must be logged in to order this item. Log in here

3" Extension rod, Dark Bronze Finish

Item#:
DHE3DBR
You must be logged in to order this item. Log in here

PS CLEARLINK-PT20/340-2.7K/N

Item#:
CS05-485-114
You must be logged in to order this item. Log in here

Eluxa NEMA 4X Horn Strobe, Whi te, Clear Lens, FIRE, with 4X

Item#:
EL4XHS-FW
You must be logged in to order this item. Log in here

LCD Fire Annunciator GEM-C and FireLink, Red

Item#:
GEMC-FK1
You must be logged in to order this item. Log in here

L-SERIES 2ND GEN. LOW FREQUENC Y SOUNDER; WALL; WHITE; PLAIN

Item#:
HWL2-LF
You must be logged in to order this item. Log in here

ADDRESSABLE HEAT DETECTOR; WHI TE; LITESPEED; INCLUDES BASE

Item#:
H365
You must be logged in to order this item. Log in here

Mini-Horn, Continuous or Temporal 3 Sounder, White Faceplate, 12/24VDC

Features

  • Single unit is capable of 12 VDC or 24 VDC determined by the input voltage
  • Unit dimensions: 4.48in. (11.38 cm) high x 2.84in. (7.21 cm) wide x 0.5in. (1.27 cm) deep
  • Jumper selectable temporal 3 or continuous tone
  • Horn frequency is 3100Hz
  • Low current consumption
  • Terminal blocks 12 AWG to 18 AWG
  • Variety of mounting options for new construction and retrofit applications
  • Synchronize with Gentex AVSM Series control module
  • Faceplate available in red or off-white

Item#:
GX93-W
You must be logged in to order this item. Log in here
|◀ ◀ 217 - 228 of 7972 ▶ ▶|
View:
(Denotes required field.)