Napco NetLink Module, NL-MOD, will allow Napco Gemini Panels, from the P816 thru the X255, to fully, securely communicate alarms, status, supervisories, etc., pinpointed by zone over the internet to the central stations PC running NL-CSRCV Central Station application software or NetLink TCP/IP UL Receiver(s) NL-RCV-RMPCUL, below), using secure, NIST/AES 128bit encryption. At the central monitoring office, the panel module source is immediately received, authenticated as a valid account, and its alarm reports decoded and sent to awaiting CS operators for disposition. (NLMOD is initially set using NL-MODCONFIG, a download software utility for programming/configuring the panel module.)

The T-Link universal IP alarm communicator (TL300) is a valuable addition to the T-Link family of Internet/network alarm communicators. Capable of communicating with any control panel (including third-party manufacturers) that uses the Contact ID format, the simple-to-install TL300 saves end-users money by taking advantage of their existing IP networks and security equipment to create fully supervised security solutions between protected premises and central monitoring stations. This method provides flexibility and an always-on, two-way line of communication. The TL300 communication stream is small and requires only a limited amount of network bandwidth. This ensures that the integrity of the data being transferred never becomes compromised. To reduce security risks, the module utilizes industryleading, 128-bit AES encryption, polling and hardware substitution protection.

Features

• Compatible with most control panels that use the Contact ID format
• Instant, always-on IP communication
• Works over local LAN/WAN network or the Internet
• 128-bit AES encryption (NIST approved)
• Supports DHCP (dynamic IP addresses)
• Low network bandwidth requirements
• Compatible with 10/100BaseT networks
• Reports events to 2 different re ceiver IP addresses
• UL standard & encrypted line security
• 12-24 volt DC support (v1.5 and higher)
• 4 on-board programmable zone inputs and 2 programmable voltage outputs as stand-alone module
• Programmable through the PK5500 LCD keypad or T-Link Console software
• Software upgrades via network
• Compatible with Sur-Gard System I/II/III/IV monitoring station receivers
• Polling and hardware substitution protection

• StarLink™ Up/Downloadable intrusion alarm communicators
• Universal full event reporting from any panel to any central station
• EZ Activation - Automatic dialer-capture technology eliminates time-consuming web setup
• Use in primary or backup communication mode
• Full High-Speed Napco control panel remote uploading/downloading
• Compatible with any panel that communicates using Contact ID or 4/2 format
• Three programmable inputs, including smart channel (burg/fire bell input)
• Three programmable outputs• Service plan sold separately (through NapcoComNet.com)