Home  >  FIRE  > (x)
|◀ 37 - 48 of 8918 ▶|
View:

  • Circuit breaker lockout tab
  • Hex key
  • Panel identification stickers
Item#:
ELOCK-FA
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here

The EVX-RM is a supervised remote microphone for use with the EVAX 25(50) voice evacuation system. The microphone provides crystal-clear live voice messages over the system speakers. Ideal for use when the fire alarm panels are in an electrical room, and the annunciator and microphone are in the lobby.

Features

  • All-Call Remote Microphone
  • Overrides alarm tone and automatic message
  • Dead Front Cover Construction
  • Paging microphone with Press To Talk Button
  • In-Use and Fault LEDs
  • Supervised Wiring
  • May be located up to 5000 feet away from Voice Evac Panel

Item#:
EVX-RM
You must be logged in to order this item. Log in here

Supervises up to 5 remote microphones

Item#:
EVX-SC
You must be logged in to order this item. Log in here

The ECC-50/100 and ECC-50/100E are multipurpose emergency voice evacuation panels that may be used for fire applications, mass notification applications or both. These state-of the-art Primary Operator Consoles (POCs) are capable of producing either 50 or 100 watts of audio power that can be distributed to up to eight speaker circuits (i.e., zones).

Features

  • UL Listed to UL2572 Communication (Control Units Mass Notification Systems).
  • Modular design for maximum system flexibility and easy expansion.
  • 50 watts of 25 V audio power (expandable to 100 watts) RMS.
  • Optional amplifier can be configured as a backup in the event the primary amplifier fails. Amplifiers are independently powered to eliminate system interruption during a short circuit condition
  • Eight Command Input Circuits to activate messages 1 to 8:
  • Seamless integration and control when connected to select Fire-Lite panels through the ANN/ACS (EIA-485) communication bus.
  • Speaker circuits are expandable by up to 8 outputs (With an optional circuit expander module).
  • Removable terminal blocks for ease of servicing and module replacement.
  • 2 amp Notification Appliance Circuit (NAC) output, sync generator, or follower for System Sensor, Wheelock or Gentex protocols:
  • Integral supervised microphone.
  • 520HZ square wave tones can be uploaded to ECC-50/100 to meet NFPA Low Frequency requirements
Item#:
ECC-50/100
You must be logged in to order this item. Log in here
This item has been discontinued and replaced by item 
FireFighter is the easiest, most cost effective way to add smoke alarm monitoring to your 2GIG control panel. FireFighter’s unique technology monitors the existing UL smoke detectors within the home. When an alarm is detected a wireless signal is sent to the control panel which in turn contacts the central monitoring station. With interconnected hardwired smoke detectors found in most homes today, only one FireFighter is needed to monitor ALL the smoke detectors within the home.
  • Monitors any UL existing smoke detector
  • Does not impact UL or Fire Marshall approval of existing smoke detectors
  • 100% compatible with 2GIG panels and Honeywell 5800 receivers
  • Uses 1 CR123A long life lithium battery
  • FCC, IC, and ETL listed in US and Canada to UL985 standard
Item#:
2GIG-FF-345
You must be logged in to order this item. Log in here
  • Protective polycarbonate cover
  • Helps stop false alarms
  • Without horn, fire label
  • Clear spacer with gaskets
  • Helps extend the life and reliability of weather exposed manual pull stations
  • UL/cUL Listed, IP Rating 44, ADA Compliant
  • 7 in H x 5 in W x 5.2 in D
Item#:
STI-3150
You must be logged in to order this item. Log in here
  • For use with Universal Stopper covers
  • 1 1/2″ (37mm) spacer
  • Converts a flush mount unit to a surface mount unit
  • Includes spacer, gaskets, and hardware
Item#:
STI-1331
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
  • Genuine and non-flammable CO gas
  • Fast test and re-set time
  • Controllable and safe CO detector testing
  • Only CO tester approved for System Sensor 1224T / A / R CO detectors & Interlogix SpaceAir 250 CO Alarms
  • Detector manufacturer endorsed
  • UL Classified
Item#:
SOLOC6
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
|◀ 37 - 48 of 8918 ▶|
View:
(Denotes required field.)