The Model EXA-1000 Omni-directional Remote Antenna is designed to enhance the radio range of Linears receivers. This antenna can be connected to the F connector on many Linear receivers to improve their range when they must be located in poor signal reception locations. Usually an increase of 20-30% range can be expected. The versatile EXA-1000 can be mounted in a variety of ways. A 2-inch U-bolt is supplied for post or pipe mounting, or the U-bolt holes in the Base Plate can be used to screw the antenna to a wall or vertical wood brace or beam.

NOTE: Generally, the higher the antenna is mounted above ground level, the better the radio range will be.

The EXA-1000 is a 1/2 wave, center fed, vertical antenna composed of three parts: an Antenna assembly with an F connector attachment; a Base Plate assembly with radial mounting provisions; and a five-foot, 75-ohm coaxial cable. The cable connects to the antenna base on one end and the receivers F connector on the other. If the antenna must be mounted further than five feet from the receiver, an extension cable of up to a maximum of 25 feet may be used instead of the five foot cable supplied. Because of the cable resistance, the performance of the EXA-1000 may be degraded by using longer than a 25 foot cable.

Features

• Compatible with all Linear receivers with Type F antenna connector
• Receives signals in 288 to 320 MHz range
• Omni-directional remote antenna
• Includes 5 feet of coax
• U-bolt for post mounting
• Dimensions: 3 W x 19.5 H x 6 D in.
• Order number: AAE00198

Features

• Large illuminated pushbutton with caption "PUSH TO EXIT"
• Message language can be easily switched between English, Spanish, and French with 3 included interchangeable plates
• Pushbutton rated 10A@125~250VAC (3A@24VDC for SD-7202GC-PTQ)
• Includes five colored 12-inch wire leads with easy-to-attach spade lugs for fast installation
• LED Gives over 50,000 hours of illumination
• 12~24 VDC: No resistors required
• Includes stainless-steel single-gang plate
• Timed output adjustable from 1~180 seconds
• Buzzer output for audible status

The SECO-LARM SD-996C-NUVQ Electric Door Strike with Vertical Adjustment is compatible with a wide range of lock types including cylindrical, mortise, and mortise exit devices and can be configured for use in wood, aluminum, or metal doors. Included are various ANSI-sized faceplates to match the door lock type. The strike is easily field-configurable for fail-safe or fail-secure applications

• 12/24 VDC Operation
• Vertical adjustable deadbolt opening, sliding shim keeper, and deadlatch ramp accommodates a wide range of lock types
• Accommodates deadbolts up to 1 in.
• Field selectable for fail-safe or fail-secure
• Includes 5 different stainless-steel faceplates
• Includes trim plate to hide gaps in installation
• Reversible non-handed design
• Static strength  1,000 lbs. (454kg)
• Tested to 250,000 cycles (UL Tested)
• Low current draw: 300mA@12VDC & 150mA@24VDC