Features

• Clean Dead-front Construction
• 8 Megabyte MP3 driver
• 25 or 70 VRMS Field Selectable Class A / B Speaker Circuit
• 120 VAC Power Supply and Battery Charger
• Live Microphone Override of Message and Tone
• Analog Addressable Compatible
• High Reliability, No Maintenance, Fully Supervised
• Easy Installation and Operation
• Studio Quality Voice Recordings Built in Alarm and Alert Signals
• Works with 12 or 24VDC Fire Alarm Panels Works with Microprocessor based and Networked Fire Alarm Systems
• 3 Minute Message Restart on Microphone Key
• 24 Hour Backup with two 12V 7AHr Batteries

Provides Connections for up to Six Style Z (Class A) or Style Y

• 4 Class B or 2 Class A Field Selectable Speaker Circuits
• 25/70 Vrms Field Selectable
• Configurable with EVX-SL8 for Zone Selection
• Smart Power detection, provides short circuit protection
• Up to 64 circuits on a system
• Up to 50W on any circuit at 70V

The EVX-RM is a supervised remote microphone for use with the EVAX 25(50) voice evacuation system. The microphone provides crystal-clear live voice messages over the system speakers. Ideal for use when the fire alarm panels are in an electrical room, and the annunciator and microphone are in the lobby.

Features

• All-Call Remote Microphone
• Overrides alarm tone and automatic message
• Dead Front Cover Construction
• Paging microphone with Press To Talk Button
• In-Use and Fault LEDs
• Supervised Wiring
• May be located up to 5000 feet away from Voice Evac Panel

The ECC-50/100 and ECC-50/100E are multipurpose emergency voice evacuation panels that may be used for fire applications, mass notification applications or both. These state-of the-art Primary Operator Consoles (POCs) are capable of producing either 50 or 100 watts of audio power that can be distributed to up to eight speaker circuits (i.e., zones).

Features

• UL Listed to UL2572 Communication (Control Units Mass Notification Systems).
• Modular design for maximum system flexibility and easy expansion.
• 50 watts of 25 V audio power (expandable to 100 watts) RMS.
• Optional amplifier can be configured as a backup in the event the primary amplifier fails. Amplifiers are independently powered to eliminate system interruption during a short circuit condition
• Eight Command Input Circuits to activate messages 1 to 8:
• Seamless integration and control when connected to select Fire-Lite panels through the ANN/ACS (EIA-485) communication bus.
• Speaker circuits are expandable by up to 8 outputs (With an optional circuit expander module).
• Removable terminal blocks for ease of servicing and module replacement.
• 2 amp Notification Appliance Circuit (NAC) output, sync generator, or follower for System Sensor, Wheelock or Gentex protocols:
• Integral supervised microphone.
• 520HZ square wave tones can be uploaded to ECC-50/100 to meet NFPA Low Frequency requirements