S2K Commerce - Products Dropdown
S2K Commerce - Shopping Cart
S2K Commerce - Order Entry
The GEMINI GEM-P801 control panel provides up to 6 hardwired/wireless zones, a 2-wire fire zone and 2 wireless only zones. Up to eight 4-digit user codes can be programmed.
Features
- Includes RP8 Numeric Keypad
- 9 programmable zones, including 2-wire (No zone doubling)
- 6 Hardwire or wireless zones plus: 2 wireless zones plus 1 2-wire fire zone
- Use 2 optional zones at GEMRP8LCD Custom Alpha Keypad
- Uses GEMRECVXP8 wireless receiver
- 8 individually reporting user codes
- 50 event log
- PC programmable with PCD-Windows
- Line and bell-cut supervision
- Double reporting & backup reporting
- EZ wire full-size terminal strips
Features
- 8 to 96 hardwire zones/points including 8 2-wire fire zones
- Fuseless, maintenance-free operation
- Up to 96 user codes
- Up to 8 areas
- 3 on-board relay outputs; expandable to 96
- 1 on-board programmable lug
- Up to 4
- RF receivers
- Up to 15 keypads
- Up to 64 X-10 devices supported
- 800 event log
- Auto arm/disarm
- 255 event scheduler
- Supports GEM-automation alarm-to-pc automation software package interface
- Supports GEM-Developer Development Professionals Protocol for custom integration.
- Supports Phast automation systems with GEM-PHASTPAK interface
- Permits permanent panel-port connection to automation hubs using GEM-RS232 interface
GEM-P1632 Features:
GEM-K1CA Features:
Contains:
(1) HS2032NK control panel in a PC5003C cabinet
(1) HS2LCDRF9ENG Full Message LCD Hardwired Keypad with Built-in PowerG Transceiver
(1) BD4-12 12V, 4Ah battery
(1) PTD1640U standard efficiency transformer
(1) SD15WULF indoor siren
To enroll the DWS-LL, begin by placing the panel into wireless enrollment mode and then sending an enrollment signal from the LongLife sensor. Alternatively, the LongLife sensor can be enrolled by scanning its bar code using the Alula app or by entering its 8-character serial number on the interactive GeoArm web portal.
To install the DWS-LL, begin by removing the adhesive paper and adhering the LongLife contact and magnet on a door or window. Clean the surface of where you plan on mounting it. Leave a minimum of 3/16 inch clearance around the ends of the sensor to allow the cover to open. Make sure to align the alignment marks on the LongLife and magnet when mounting. Alternatively, LongLife can be used with an external contact instead of the reed switch.
The High Bond Tape (3M VHB Tape) works great if the surface is properly prepared and firm pressure is applied for over 10 seconds. The LongLife wireless performance is optimized when mounted near the top of the door in a vertical orientation.
- Low-profile design
- Easy, slide-open cover
- Battery pull-tab enrollment
- 5-year product warranty
- 10-year battery life (replaceable)
