• 600TVL Image Resolution
• 3.6mm/F2.0 Board Lens
• 12VDC Voltage
• 1/3 in. SHARP CCD Image Sensor
• 150mA Power consumption
• AGC & Auto White Balance
• 14-122F (-10-50C) Operating Temperature

XT Series control panels can be plugged in and powered by a 12V DC power adapter for sites where a power supply is availabe. Alkaline batteries provide 3-6 months backup power (depending on alarm activity) if the local power supply fails.

Features:

• 12V DC power adapter with surge and lightning protection
• Compatible with XT Series control panels
• Required power option when XT panels are communicating over Ethernet or using programmable inputs and/or outputs
• Power adapter has screw terminals for custom power cable length if desired
• Not recommended for use below freezing temperatures

The HUB-T Series Hold-Up Buttons provide two sets of momentary or latching DPDT contacts for actuating surveillance cameras or other security applications, in addition to the hold-up signal. The two sets of contacts may be used independently of each other, or they may be wired in series with a jumper wire for additional protection against false alarms.

Features

Enable bi-directional communication with the IMAGE Sensor 3

Easy to install into any GC2e panel

Replaces existing 345 MHz receiver and provides both a 900 MHz transceiver and 345 MHz receiver

Provides support for:

• Legacy 345 Sensors
• eSeries encrypted 345 Sensors
• 2GIG-IMAGE3

Requires GC2e security panel with firmware 1.23 or later.

Bi-Directional Overhead Door-Track Mount Type For 2 1/2 inch Rails