AL300ULMR multi-output access control power supply/charger is specifically designed for use with access control systems and accessories. This unit converts a 115VAC / 60Hz input into five (5) individually protected Class 2 Rated power limited 12VDC or 24VDC outputs. Each output will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. These outputs will operate in both Fail-Safe and Fail-Secure modes. Controlled trigger input is achieved through normally open (N.O.) or normally closed (N.C.) supervised input or the polarity reversal from an FACP (Fire Alarm Control Panel). A form "C" dry output relay enables HVAC Shutdown, Elevator Recall or may be used to trigger auxiliary devices.

Altronix T2MK3F8Q is pre-assembled and consists of Trove2M2 enclosure with factory installed Altronix power supply/charger(s) and sub-assemblies. This kit also accommodates various combinations of Mercury boards for up to eight (8) doors in a single enclosure.

• Input: 120VAC 60Hz/3.5A.
• Output:
  • 24VDC up to 5.8A max current.
  • Eight (8) Fail-Safe/Fail-Secure or Dry Form "C" Outputs
• Fully assembled kit includes:
  • Trove2 enclosure with TM2 backplane
  • One (1) eFlow6NB - Power Supply/Charger
  • One (1) LINQ2 - Network Communications Module
  • One (1) ACM8 - Fused Access Power Controller
  • One (1) VR6 - Voltage Regulator
  • One (1) PDS8 - Dual Input Power Distribution Module
• Back-up Battery (not included):
  • Capacity: 12AH / 12VDC (Up to 4 within enclosure); 40 AH / 65 AH (requires separate enclosure).
  • Type - Sealed lead acid or gel type.
  • Fuse Rating: 10A/32V
  • Failover - Upon AC loss, instantaneous.
• Supervision:
  • AC Failure - Form "C" contacts.
  • Battery - Form "C" contacts.
  "
  • Low DC Power Shutdown - Shuts down DC output terminals if battery voltage drops below 71-73% for 12V units and 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.
• LED Indicators:
  • Input - 120VAC is present.
  • DC Output - Powered.
  • Battery - Discharged or not connected.

Vertiline33D Rack Mount DC Power Supply provides sixteen (16) filtered and electronically regulated power outputs in a space saving 1U EIA 19 in. rack mount chassis.Vertiline Rack Mount Power Supplies are also available in 24VDC and eight (8) outputs configurations.

• Sixteen (16) power LEDs.
• Illuminated master power disconnect circuit breaker with manual reset.
• IEC 320 - 3-wire grounded line cord (detachable).
• Removable terminal blocks with locking screw flange

Altronix T2MK3F4Q is pre-assembled and consists of Trove2M2 enclosure with factory installed Altronix power supply/charger(s) and sub-assemblies. This kit also accommodates various combinations of Mercury boards for up to four (4) doors in a single enclosure.

• Input: 120VAC 60Hz/3.5A.
• Output:
  • 24VDC up to 5.8A max current.
  • Four (4) Fail-Safe/Fail-Secure or Dry Form "C" Outputs
• Fully assembled kit includes:
  • Trove2 enclosure with TM2 backplane
  • One (1) eFlow6NB - Power Supply/Charger
  • One (1) LINQ2 - Network Communications Module
  • One (1) ACM4 - Fused Access Power Controller
  • One (1) VR6 - Voltage Regulator
  • One (1) PDS8 - Dual Input Power Distribution Module
• Back-up Battery (not included):
  • Capacity: 12AH / 12VDC (Up to 4 within enclosure); 40 AH / 65 AH (requires separate enclosure).
  • Type - Sealed lead acid or gel type.
  • Fuse Rating: 10A/32V
  • Failover - Upon AC loss, instantaneous.
• Supervision:
  • AC Failure - Form "C" contacts.
  • Battery - Form "C" contacts.
  • Low DC Power Shutdown - Shuts down DC output terminals if battery voltage drops below 71-73% for 12V units and 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.
• LED Indicators:
  • Input - 120VAC is present.
  • DC Output - Powered.
  • Battery - Discharged or not connected.

Altronix NetWay1DWP outdoor single port midspan injector provides Hi-PoE (60W), PoE (30W), and PoE (15W). The unit is ideal for use with outdoor IP cameras and PTZs, WiMAX modems and WLAN access points. NetWay1DWP features a lightweight NEMA 4/4X IP66-11 rated enclosure that can be wall or pole mounted. The unit operates at 115VAC or 230VAC input. Model NetWay1DWPH features enclosure with three (3) 5/8" wiring inlets and includes NEMA rated wire glands.