|◀ 685 - 696 of 764 ▶|
View:
You must be logged in to order this item. Log in here

Z-Wave white wall Outlet. One controlled, one standard outle

This item has been discontinued and replaced by item 
Item#:
WO15Z-1
You must be logged in to order this item. Log in here
  • Rugged aluminum housing and adjustable L bracket type magnet
  • Standard gap: 2" (51mm)
  • 24" (61cm) armored cable
  • Epoxy sealed for protection from moisture and impact
  • Programmed from VISTA keypad
  • Switch Type: Form A (SPST) Reed
  • Contact Rating: 100ma @ 28VDC
  • Honeywell Exclusive: Patent polling loop technology
Item#:
4959SN
You must be logged in to order this item. Log in here
The 4208SN Remote Point Module (RPM) is an eight-zone expander that allows the use of available expansion zones on Honeywell VISTA controls that support V-Plex® polling loop devices.
  • Can be used on controls that support up to 250 zones
  • Can be optionally powered from an external DC power supply to reduce the amount of current draw from the polling loop
  • Uniquely identified eight EOLR supervised zones (all zones use 10K resistors, supplied)
  • Each zone is identified by a unique serial number, which is assigned via on-board DIP switches
  • Detects faults on all zones within 400ms of occurence
  • Loops A & B can be programmed for fast (10ms) response
  • Provides cover tamper protection, which may be enabled or disabled via on board DIP switches
Item#:
4208SN
You must be logged in to order this item. Log in here

The 2020PLT is a rugged reinforced metallic plate for the RLS-2020 Laser Scan Detector allowing the detector to be attached to a wall. It is perfect for uneven walls and hard surfaces such as cement, concrete and brick.

Item#:
2020PLT
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
Item#:
VXS-FC (BL)
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here
You must be logged in to order this item. Log in here

Features

Enable bi-directional communication with the IMAGE Sensor 3

Easy to install into any GC2e panel

Replaces existing 345 MHz receiver and provides both a 900 MHz transceiver and 345 MHz receiver

Provides support for:

  • Legacy 345 Sensors
  • eSeries encrypted 345 Sensors
  • 2GIG-IMAGE3

Requires GC2e security panel with firmware 1.23 or later.

Item#:
2GIG-XCVR5E-345
You must be logged in to order this item. Log in here
|◀ 685 - 696 of 764 ▶|
View:
(Denotes required field.)