S2K Commerce - Products Dropdown
S2K Commerce - Shopping Cart
S2K Commerce - Order Entry
Item#:
QBS-0070
You must be logged in to order this item.
Log in here
Item#:
PNC-0018
You must be logged in to order this item.
Log in here
You must be logged in to order this item.
Log in here
Item#:
P500-125
You must be logged in to order this item.
Log in here
Basic Probe Package - White ABS Enclosure, HA2, GRND2, 12VDC1, RXTX612 (Wireless Chime Package) *Basic Probes Only (Probe sold separately) Â
Item#:
P5W1S
You must be logged in to order this item.
Log in here
The RM-2 Relay Module is used as an end-of-line (EOL) power supervision module for 4-wire smoke detectors. The RM-2 is used with the Polarity Reversal Module PRM4W and DSC FSA-410 series smoke detectors. When the PRM-4W reverses polarity on the smoke detector loop to activate all smoke detector sounders, the RM-2 Relay will continue to operate normally (regardless of input power polarity). Refer to the PRM-2W/4W Polarity Reversal Module
Item#:
RM-2
You must be logged in to order this item.
Log in here
Item#:
TX-6-HS WHITE
You must be logged in to order this item.
Log in here
Item#:
T3SPK7724SPQ
You must be logged in to order this item.
Log in here
Item#:
VCS100K
You must be logged in to order this item.
Log in here
The M1XSLZW is a specialized Elk-M1 serial expander for connecting an M1 Control to Z-Wave enabled devices through a Leviton VRC0P+3 Z-Wave Serial Interface. Z-Wave is a wireless, low power, "mesh" network technology widely used for automating devices such as: Lights, Thermostats, Electronic Locks, etc. Z-Wave empowers devices to be remotely controlled from across the room or across the world with benefits such as energy savings, convenience, and comfort.
The VRC0P+3 is known as a Z-Wave Secondary Controller. It must be included as a permanent member of the Z-Wave network as its job is to maintain contact with all Z-Wave devices. It communicates via RS232 to the M1XSLZW which translates the protocol into the M1 control. This allows commands to be sent and received on the Z-Wave network.
- Activity/Status LED (Orange)
- Auto-Reset Hardware Watchdog Circuit
- Addressable (1-7) TYPE 5 Databus ID
- Connection to VRC0P+3: DB9M 9 Pin Port
- Connection to M1: Elevator Screw Terminals (4)
- Operating Voltage: 12 Volts D.C.
- Current Draw: 31mA
- Housing: 4.25" x 6.375" x 2.125"
- Circuit Board: 2.25" x 3.95"
Item#:
M1XSLZW
You must be logged in to order this item.
Log in here
Item#:
145LEDMR48240A
You must be logged in to order this item.
Log in here
S2K Administration - Form Template Display
(Denotes required field.)
