• Emergency Exit Buttons offer additional safety, as required by code, for possible malfunction of motion exit sensor
• Mounted next to door
• Momentarily pressing the button releases door for 30 seconds
• Retriggerable
• Single Gang or Narrow Stile
• SPST 3 Amp wet N/C contacts
• Operates on 12 or 24 VDC (must be same voltage as the installed lock)
• For indoor use only
• Includes switchable green, red and blue ADA lenses
• UL Listed

The heavy duty GL1 Electromechanical Gate Lock provides weather-resistant access control for a wide range of gate applications. The GL1 provides 2000lbs of holding force for electrical and manually operated indoor or outdoor gates where preload is a concern. Ideal for swinging or sliding Product features vehicle, pedestrian, or stock gate access control.

Features

• 2,000 lbs holding force
• Operates under preload up to 100lbs
• Automatic dual voltage - no field adjustment required
• Accepts a standard mortise cylinder with Adams Rite MS cam for manual key override (not included, see spacer guide below)
• Self-aligning receiver (+/- 1/2 in. horizontally) helps compensate for gate misalignment and sag
• Tamper resistant cast housing
• Optional latch status monitor
• Surface mount
• MagnaCare lifetime replacement, no fault warranty

• Emergency Exit Buttons offer additional safety, as required by code, for possible malfunction of motion exit sensor
• Mounted next to door
• Momentarily pressing the button releases door for 30 seconds
• Retriggerable
• Single Gang or Narrow Stile
• SPST 3 Amp wet N/C contacts
• Operates on 12 or 24 VDC (must be same voltage as the installed lock)
• For indoor use only
• EEB3N includes switchable green and red lenses
• UL Listed

Altronix ACM8 converts one (1) 12 to 24 volt AC or DC input into eight (8) independently controlled fuse protected outputs. These power outputs can be converted to dry form C contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. ACM8 will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. This unit is designed to be powered by one common power source which will provide power for both the board operation and locking devices, or two (2) totally independent power sources, one (1) providing power for board operation and the other for lock / accessory power. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.

Features

• Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs.
  • Fire Alarm disconnect input options:
    • a) Normally open (NO) or normally closed (NC) dry contact input.
    • b) Polarity reversal input from FACP signaling circuit.
• FACP output relay (form "C" contact rated @ 1A 28VDC not evaluated by UL).
• Removable terminal blocks facilitate ease of installation.