|◀ ◀ 37 - 44 of 44 ▶ ▶|
View:

Water Detection, Surface Senso r, Supervised For use with En

Item#:
W-S-S
You must be logged in to order this item. Log in here

Wireless Flood Detector with 6-Foot Wire

The WS4985 Flood Detector is a wireless detector designed to work with the Alexor Wireless Panel as well as DSC 1-Way Wireless Receivers (see Compatibility List for further details). The WS4985 Flood Detector senses the presence of water in basements, laundry rooms, bathrooms, kitchen and numerous other areas where water may leak or flood, prompting advance warning of potential flooding.

The WS4985 is a 1-way wireless transmitter consisting of a probe connected to a wireless transmitter via a 6-foot (1.82 m) wire. The transmitter is installed at a higher level on the wall with the probe located at floor level or a desired height. In the event that there is a water leak, the probe will detect the moisture and deliver the information to the transmitter on the wall. The transmitter then sends the signal to either the Alexor Wireless Panel or DSC 1-Way Wireless Receivers to trigger the alarm. It is important to note that although the probe is sensitive, it has been designed to be immune to false triggers such as floor mopping, because the sensor head is recessed into the probes housing.

If the WS4985 is ever damaged or tampered with perhaps if the wire between the transmitter and the probe is cut), its trouble status will immediately signal the Alexor or DSC 1-Way Wireless Receivers and the device will instantly notify the alarm system. The detector also communicates low battery issues

Features:

  • Based on WS4945 wireless door/window contact
  • Water probe through a (1.8 m )6 foot-wire
  • Fully supervised
  • Built-in reed switch
  • Normally closed external contact input
  • 1 lithium battery included
  • Case and wall tamper
  • End-of-line resistor
  • 4 year battery life
Item#:
WS4985
 
Spec Sheet
You must be logged in to order this item. Log in here

Water Sensor, detects conductive, non-flammable liquids

Item#:
SSW-113H
You must be logged in to order this item. Log in here

Water Detection, Surface Senso r, Unsupervised For use with

Item#:
W-S-U
You must be logged in to order this item. Log in here

Temp Alert (Single Output) Al arm range: 50 to 130 F (10 t

Item#:
TA-1
You must be logged in to order this item. Log in here

Ring Flood & Freeze Sensor, 2-Pack

Place Sensors near water sources in the home to stay ahead of potential leaks and frozen pipes. You’ll receive notifications when water is detected or when the temperature drops below 40°F.
  • Requires the Ring Alarm Security Kit
  • Sends mobile and email notifications
  • Place near sinks, bathtubs, showers, refrigerators, water heaters, water coolers, toilets, basements and any other sources of potential leaks
Item#:
4SF2S9-0EN0
You must be logged in to order this item. Log in here

Ring Flood & Freezer Sensor

Place Sensors near water sources in the home to stay ahead of potential leaks and frozen pipes. You’ll receive notifications when water is detected or when the temperature drops below 40°F.
  • Requires the Ring Alarm Security Kit
  • Sends mobile and email notifications
  • Place near sinks, bathtubs, showers, refrigerators, water heaters, water coolers, toilets, basements and any other sources of potential leaks
Item#:
4SF1S8-0EN0
You must be logged in to order this item. Log in here

2GIG Encrypted Flood and Temperature Sensor

Perfect sensor to alert the home owner of a flood or excessive change in temperature.
Once the sensor probe detects the presence of water for three (3) minutes, the integral transmitter will send a wet alarm transmission to the security/control panel. The probe will also send a restore (dry) report when the presence of liquid is no longer detected by the flood probe for three (3) minutes. For flood reporting, the sensor requires the installation of the supplied external flood probe. The sensor is capable of detecting clean or dirty fresh water, salt water, or tap water.
  • Encrypted Protocol for Enhanced Security
  • Detects standing water that reaches the sensor probe and notifies the panel
  • Sends trouble alert to the panel when the ambient temperature exceeds 84 deg. F
  • Sends trouble alert to the panel when the ambient temperature falls below 42 deg. F
  • Ships with long life lithium battery life (typical battery life of 5 years)
  • ETL listed
  • Requires Firmware Version 1.14 or later for GC2 panel and 3.1 or later for GC3
Item#:
2GIG-FT1E-345
You must be logged in to order this item. Log in here
|◀ ◀ 37 - 44 of 44 ▶ ▶|
View:
(Denotes required field.)