MDF-300 Dual Monitor Module The MDF-300(A) Dual Monitor Module is intended for use in intelligent, two-wire systems. It provides two independent twowire initiating device circuits (IDCs) at two separate, consecutive addresses. It is capable of monitoring normally open contact fire alarm and supervisory devices. The module has a single panelcontrolled LED.

Addressable Mini-Monitor Module, One Style B (Class B) Initiating Device Circuit for Monitoring N/O contact devices, does not include a polling LED

The MMF-301 monitor module can be installed in a single gang junction box directly behind the monitored unit. Its small size and light weight allow it to be installed without rigid mounting. The MMF-301 is intended for use in intelligent, two-wire systems where the individual address of each module is selected using rotary switches. It provides a two-wire initiating circuit for normally open contact fire alarm and security devices. This module can be used to replace an M301 module in existing systems.

The CRF-300 Addressable Relay Module provides the system with a dry-contact output for activating a variety of auxiliary devices, such as fans, door holders, dampers, control equipment, etc. Addressability allows the dry contact to be activated through panel programming, on a select basis. LiteSpeed is a communication protocol developed by FireLite Engineering that greatly enhances the speed of communication between analog intelligent devices. Intelligent devices communicate in a grouped fashion. If one of the devices within the group has new information, the panel CPU stops the group poll and concentrates on single points. The net effect is response speed greater than five times that of other designs.

Features

• Built-in type identification automatically identifies these devices to the control panel.
• Internal circuitry and relay powered directly by two-wire SLC loop.
• Integral LED blinks green each time a communication is received from the control panel and turns on in steady red when activated.
• High noise immunity (EMF/RFI).
• Wide viewing angle of LED.
• SEMS screws with clamping plates for wiring ease.
• Direct-dial entry of address: 01 159 for MS-9600(A) series

The SD500-ANM is an addressable notification module and provides supervised monitoring of wiring to the load devices that require an external power supply to operate such as bells, horns, and strobes.

Features

• Flexible solution for adding notification circuits where needed
• DIP switch programming for fast installation
• Support for Class B (Style Y) or Class A (Style Z) wiring
• Attractive ivory cover plate
• Polling LED visible through the cover plate
• UL listed

The SK-MINIMON is an addressable mini-monitor module that acts as an interface to dry contact devices such as waterflow switches and conventional pull stations. Due to its small size the SK-MINIMON can be mounted in a single gang junction box directly behind the monitored device.

Features

• Single contact monitor
• Support for Class B (Style B) contact monitor wiring
• Small and lightweight size allows for flexible mounting options
• Rotary address switches for fast installation
• UL listed