The MMF-300 Monitor Module is intended for use in intelligent, two-wire systems, where the individual address of each module is selected using the built-in rotary switches. It provides either a two-wire or four-wire fault-tolerant Initiating Device Circuit (IDC) for normally-open-contact fire alarm and supervisory devices. The module has a panel-controlled LED indicator. The MMF-300(A) can be used to replace M300 modules in existing systems.

Features

• Built-in type identification automatically identifies this device as a monitor module to the control panel.
• Powered directly by two-wire SLC loop. No additional power required.
• High noise (EMF/RFI) immunity.
• SEMS screws with clamping plates for ease of wiring.
• Direct-dial entry of address: 01  159 on MS-9600 series panels, 01  99 on other compatible systems.
• LED flashes during normal operation and latches on steady to indicate alarm.

The CMF-300 Addressable Control Module provides FireLite intelligent control panels a circuit for Notification Appliances (horns, strobes, etc.). Addressability allows the CMF-300 to be activated through panel programming, on a select (zone or area of coverage) basis. LiteSpeed is a communication protocol developed by FireLite Engineering that greatly enhances the speed of communication between analog intelligent devices. Intelligent devices communicate in a grouped fashion. If one of the devices within the group has new information, the panel CPU stops the group poll and concentrates on single points. The net effect is response speed greater than five times that of other designs.

Features

• Built-in type identification automatically identifies these devices to the control panel.
• Internal circuitry powered directly by two-wire SLC loop. The CMF-300 module requires power (for horns, strobes, etc.).
• Integral LED blinks green each time a communication is received from the control panel and turns on steady red when activated.
• High noise immunity (EMF/RFI).
• The CMF-300 may be used to switch 24-volt NAC power.
• Wide viewing angle of LED.
• SEMS screws with clamping plates for wiring ease.
• Direct-dial entry of address: 01 159 for MS-9600 series panels, 01  99 on MS-9200UDLS and MS-9050UD.

The EVS-50W is an intelligent 50 watt amplifier for use with version 14.0 or newer 5820XL-EVS. The EVS-50W is used to amplify audio messaging throughout an area or facility. The EVS-50W is capable of producing 50 watts of audio power over 4, expandable to 8, fully programmable speaker circuits.

Features

• 50 watts of audio power
• Comes with 4 fully programmable Class A or Class B speaker circuits
• 25 or 70.7 Vrms operation
• Expansion up to 8 speaker circuits with the EVS-CE4
• Six wire connection to the 5820XL-EVS system: two wires for the Voice Bus (VBUS) and four wires for the SBUS connections
• Can be mounted up to 6000 feet away from the 5820XL-EVS control panel
• 120 VAC or 240 VAC operation
• UL 864 and UL 2572