|◀ ◀ 157 - 168 of 23697 ▶ ▶|
View:

Single-Door Electromagnetic Lock w/1,200LB Holding Force, 12 or 24 VDC

  • 1,200-lb Holding force
  • Anodized aluminum housing (US 28)
  • Selectable 12/24 VDC operation
  • No residual magnetism
  • MOV surge protection
  • Adjustable mounting bracket
  • Complete mounting hardware for typical installations
  • "L" and "Z" brackets available for easy mounting
  • Detachable faceplate
Item#:
E-941SA-1200
You must be logged in to order this item. Log in here

DIN Rail Enclosure 1 x 1.5 mount metal cabinet for instal

Item#:
EN-DIN-11
You must be logged in to order this item. Log in here

AC-215IP installed in ME-1015 with Type B plug power cable

  • Full online and offline operation
  • Supports for 30,000 active credentials + 30,000 PIN codes, 128 access groups, 128 access areas, 128-time zones, 64 holidays and 32 NG Smart Links for automation
  • 20,000 non-volatile, FIFO, records the event log while offline
  • Real-time clock with super-cap keeps time for up to 2 weeks when total power loss (no batteries to replace)
  • Supports a wide range of Rosslare and third-party readers with a wide range of Wiegand reader formats and PIN keypad formats
  • Supports a large variety of locking hardware with built-in logic options to support a wide range of lock strikes, deadbolts, electric strikes, maglocks, and handle locks (Fail Safe, Fail Secure)
Item#:
AC-215IP-BU
You must be logged in to order this item. Log in here

Corporate 1000 Fee

Item#:
MC1000
You must be logged in to order this item. Log in here

ACT-31B, 1 Button Mini TX Transmitter

The Model ACT-31B 1-Channel Block Coded Key Ring Transmitter is designed for use with Linear’s access control products. The Model ACT-31B is a single-channel device supplied with a quick-disconnect key ring. Also included are lithium batteries with a five-year service life. A unique 10-second time-out feature prevents the system from being shut down by a single transmitter transmitting continuously.

The transmitter is MegaCode format, which means each transmitter is factory preprogrammed with one of over 1,000,000 codes, virtually eliminating the possibility of code duplication. Because the receiver ”learns” each specific code, no unauthorized person can gain access to the system by reprogramming a transmitter.

Block coded transmitters are factory programmed to a sequential series of transmitter ID codes. When used with a Linear access controller, transmitters can be locally or remotely programmed into memory by entering the first and last codes of the block into the system. Facility codes can be selected to further customize the system.
 
  • Compatible with all Linear access receivers and controllers
  • Supplied with quick-disconnect key ring
  • Sold in lots of 10
  • Power: Two 2016 batteries
  • Codes: Factory block coded in MegaCode format
  • RF frequency: 318 MHz
Item#:
ACT-31B
You must be logged in to order this item. Log in here

Armature Housing for 600lbs Ma gnetic Lock

Item#:
CX-MA0612
You must be logged in to order this item. Log in here

"Z" Bracket for mounting E-941 SA-600, E-941SA-600PQ, E-941DA

Item#:
E-941S-600/ZQ
You must be logged in to order this item. Log in here

Glass Mount Kit for 600lbs Mag netic Lock

Item#:
CX-MA0611
You must be logged in to order this item. Log in here

Access Power Controller, 8 PTC Class 2 Relay Outputs, FAI, Board

Altronix ACM8CB converts one (1) 12 to 24 volt AC or DC input into eight (8) independently controlled Class 2 rated PTC protected power-limited auto-resettable outputs rated at 2.5A each. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. ACM8CB will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. This unit is designed to be powered by one common power source which will provide power for both the board operation and locking devices, or two (2) totally independent power sources, one (1) providing power for board operation and the other for lock / accessory power. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.

Features

  • Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs.
    Fire Alarm disconnect input options:
    • a) Normally open (NO) or normally closed (NC) dry contact input.
    • b) Polarity reversal input from FACP signaling circuit.
  • FACP output relay (form "C" contact rated @ 1A 28VDC not evaluated by UL).
  • Removable terminal blocks facilitate ease of installation.

Item#:
ACM8CB
You must be logged in to order this item. Log in here

Kantech ioSMART Wireless Weiga nd Reciever.

Item#:
KT-WLS-WIE
You must be logged in to order this item. Log in here

2-Door Expander

The MD-D02B is a plug-in expansion module for Rosslare’s AC-225x-B access control panels that provides a 2-reader interface, 4 supervised inputs with end-of-line (EOL) resistor protection, and 4 relay outputs (5 Amp Form-C N.O./N.C.) to the panel. Installation of the module takes under one minute with the tailored expansion port in the panels and auto-recognize by the panel. Once it is installed and the panel is powered on, the expansion is recognized by the AxTraxNG server, and the MD-D02B can be programmed for access control and automation. Advanced communication with the controller allows for firmware update and real-time event logging, with support for full offline operation by the host panel.
  • Additional two proximity readers or keypads
  • Four relay outputs and four supervised inputs to the access control panel
  • Wiegand or Clock-and-Data transmission keypad or biometric reader compatibility
  • LED status feedback for 12 V power and relay activation
  • Cost effective and modular installation
  • Input and output configurability using Rosslare’s AxTraxNG™ software
Item#:
MD-D02B
You must be logged in to order this item. Log in here

1/2 Inch Spacer for 1200 lb. Lock

Item#:
AM6300
You must be logged in to order this item. Log in here
|◀ ◀ 157 - 168 of 23697 ▶ ▶|
View:
(Denotes required field.)