S2K Commerce - Products Dropdown
Actions
S2K Commerce - Shopping Cart
Actions
S2K Commerce - Order Entry
Actions
The Alula DWS-LL is an encrypted, LongLife, wireless door or window sensor designed to be used with the Alula Connect+ Panel. The DWS-LL sensor detects opening and closings of doors and windows. It can secure just about anything that opens with its simple peel-and-stick mounting solution. The DWS-LL will alarm, when the Connect+ Panel is armed and the magnet is pulled away from the contact.
To enroll the DWS-LL, begin by placing the panel into wireless enrollment mode and then sending an enrollment signal from the LongLife sensor. Alternatively, the LongLife sensor can be enrolled by scanning its bar code using the Alula app or by entering its 8-character serial number on the interactive GeoArm web portal.
To enroll the DWS-LL, begin by placing the panel into wireless enrollment mode and then sending an enrollment signal from the LongLife sensor. Alternatively, the LongLife sensor can be enrolled by scanning its bar code using the Alula app or by entering its 8-character serial number on the interactive GeoArm web portal.
To install the DWS-LL, begin by removing the adhesive paper and adhering the LongLife contact and magnet on a door or window. Clean the surface of where you plan on mounting it. Leave a minimum of 3/16 inch clearance around the ends of the sensor to allow the cover to open. Make sure to align the alignment marks on the LongLife and magnet when mounting. Alternatively, LongLife can be used with an external contact instead of the reed switch.
The High Bond Tape (3M VHB Tape) works great if the surface is properly prepared and firm pressure is applied for over 10 seconds. The LongLife wireless performance is optimized when mounted near the top of the door in a vertical orientation.
Product Features:
- Low-profile design
- Easy, slide-open cover
- Battery pull-tab enrollment
- 5-year product warranty
- 10-year battery life (replaceable)Â
Item#:
DWS-LL
You must be logged in to order this item.
Log in here
The RE114 Smoke Detector is a highly reliable smoke detector with a photoelectric detection element and built-in temporal 3 sounder. Long range transmitter and a detection element that is UL217 certified.
- UL217 and ULC531 listings
- Smoke and heat detection
- 5 year warranty
Item#:
RE114
You must be logged in to order this item.
Log in here
- Tri-Mode Environmental Sensing:
- Flood, high and low temp
- Freeze - for Furnace Failure - Under 45 degrees F
- Overheat - for Furnace runaway or Air Conditioning failure - Over 100 Degrees F
- 3 unique wireless IDs or Loops: one for each function
- Cover and wall tamper
- 3-5x more range than competing "puck" style sensors.
- 8-10 year battery life on CR2032 battery.
- IP67 waterproof rating
- 2.43 x 2.48 x 1.17 inches
Item#:
RE218
You must be logged in to order this item.
Log in here
- Maximum cable run: 1,000’ (305 m) [22 AWG twisted pair]
- Fully submersible waterproof construction.
- Includes terminal block for easy installation.
- Works with TEMP-P-H if application requires protected sensor.
- Do NOT put EnviroAlert consoles or wireless sensors in freezer/cooler. Use wired sensor
Item#:
TEMP-L-W
You must be logged in to order this item.
Log in here
The REX14 Smoke Detector is a highly reliable smoke detector with a photoelectric detection element and built-in temporal 3 sounder. Long range transmitter and a detection element that is UL217 certified.
- UL217 and ULC531 listings
- Smoke and heat detection
- 5 year warrantyÂ
Item#:
RE314
You must be logged in to order this item.
Log in here
- Industry-leading wireless range and battery life
- Wide magnetic gap distance
- Two built-in external contact zones
- Secure encrypted wireless transmissions
- IP67 waterproof enclosure rating
- 5-year warranty
Item#:
RE107
You must be logged in to order this item.
Log in here
The RE214T 2GIG Compatible Smoke Alarm is a fire-protection device that alarms when it detects smoke or temperatures above 135°F (57°C).
- UL217 and ULC531 listings
- Smoke and heat detection
- 5 year warranty
Item#:
RE214T
You must be logged in to order this item.
Log in here
The IQ Carbon is a monitored detector ensures your home stays safe from dangerous invisible carbon monoxide gas. Connecting directly to the IQ panel, this device is operating 24-7, whether your system is armed or not, and can inform you if any danger is present in your home.
- Especially useful in homes with high risk of carbon monoxide leaks from appliances such as stoves, furnaces, and more.
- Monitoring for carbon monoxide gas 24-7
- Test button to ensure device is operating correctly
- Built-in alarm sounds in addition to panel siren
- Causes panel to emit fire tone and alerts monitoring station of carbon monoxide
- Power Source: One 3-volt CR123A Panasonic Lithium Battery (included)
- Audible Signal (temp 4 tone): 85 dBA min. in alarm (at 10ft (3m))
- Operating Current: 10 μA
- Temperature Range: 40°F (4.4°C) to 100°F (37.8°C)
- Operating Humidity Range: 15% to 95% Relative Humidity, non-condensing
- Pending Agency Listings: UL standard 2075, UL 2034 and CSA 6.19-01
Item#:
QS5210-840
You must be logged in to order this item.
Log in here
The Smoke Alarm uses photoelectric smoke sensing technology, paired with a fixed heat limit, and a rateof-rise limit. The audible alarm will signal for sensing smoke, heat, and temp rate-of-rise. Sounds before most common hard-wired alarms, providing early warnings for lifethreatening fire and smoke events.
- UL217 and ULC531 listings
- Smoke and heat detection
- 5-year warranty
Item#:
RE614
You must be logged in to order this item.
Log in here
The Honeywell compatible smoke and heat alarm is a fire-protection device that alarms when it detects smoke or temperatures above 135°F (57°C).
- UL217 and ULC531 listings
- Smoke and heat detection
- 5 year warranty
Item#:
RE214
You must be logged in to order this item.
Log in here
S2K Administration - Form Template Display
Actions
(Denotes required field.)