|◀ ◀ 265 - 276 of 23802 ▶ ▶|
View:

All ACI/ECU System Firmware Upgrade

Item#:
FWSACU
You must be logged in to order this item. Log in here

PIR Request to Exit Sensor, Gray

The DS150i Series consists of the DS150i Detector (light gray) and the DS151i Detector (black). They are specifically designed for Request-to-exit (REX) applications. The DS150i and DS151i detect motion in their coverage area and signal an access control system or door control device.

Features

  • Single or double door use
  • Wall or ceiling mountable
  • Internal vertical pointability
  • Wrap-around coverage pattern
  • Selectable relay trigger mode
  • Selectable fail safe/fail secure modes

Item#:
DS150I
You must be logged in to order this item. Log in here

Armoured Cable 25FT x 3/16"ID

Item#:
AC25
You must be logged in to order this item. Log in here

Network Communication Board CB-485 BOARD

  • Where higher security is required for communication, use the NETCOM6P with AES Rijndael (NIST approved) encryption algorithm 
  • A user-defined encryption key, which can be can be 128 bits, 192 bits, or 256 bits, minimizes the possibility of communication breach 
  • Includes a Keyscan NETCOM Program Tool utility for custom installation programming  
  • Also available as an off-board module, NETCOM2 for legacy panels and select integrations 
  • Fast and easy installation for each ACU 
  • Requires Static IP addresses for proper operation 
  • Simplies both installation and maintenance procedures 
  • Easy to program with included utility 
Item#:
NETCOM2P
You must be logged in to order this item. Log in here

Glass Mount Kit for 600lbs Mag netic Lock

Item#:
CX-MA0611
You must be logged in to order this item. Log in here

Access Power Controller, 8 PTC Class 2 Relay Outputs, FAI, Board

Altronix ACM8CB converts one (1) 12 to 24 volt AC or DC input into eight (8) independently controlled Class 2 rated PTC protected power-limited auto-resettable outputs rated at 2.5A each. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. ACM8CB will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. This unit is designed to be powered by one common power source which will provide power for both the board operation and locking devices, or two (2) totally independent power sources, one (1) providing power for board operation and the other for lock / accessory power. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.

Features

  • Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs.
    Fire Alarm disconnect input options:
    • a) Normally open (NO) or normally closed (NC) dry contact input.
    • b) Polarity reversal input from FACP signaling circuit.
  • FACP output relay (form "C" contact rated @ 1A 28VDC not evaluated by UL).
  • Removable terminal blocks facilitate ease of installation.

Item#:
ACM8CB
You must be logged in to order this item. Log in here

Kantech ioSMART Wireless Weiga nd Reciever.

Item#:
KT-WLS-WIE
You must be logged in to order this item. Log in here

2-Door Expander

The MD-D02B is a plug-in expansion module for Rosslare’s AC-225x-B access control panels that provides a 2-reader interface, 4 supervised inputs with end-of-line (EOL) resistor protection, and 4 relay outputs (5 Amp Form-C N.O./N.C.) to the panel. Installation of the module takes under one minute with the tailored expansion port in the panels and auto-recognize by the panel. Once it is installed and the panel is powered on, the expansion is recognized by the AxTraxNG server, and the MD-D02B can be programmed for access control and automation. Advanced communication with the controller allows for firmware update and real-time event logging, with support for full offline operation by the host panel.
  • Additional two proximity readers or keypads
  • Four relay outputs and four supervised inputs to the access control panel
  • Wiegand or Clock-and-Data transmission keypad or biometric reader compatibility
  • LED status feedback for 12 V power and relay activation
  • Cost effective and modular installation
  • Input and output configurability using Rosslare’s AxTraxNG™ software
Item#:
MD-D02B
You must be logged in to order this item. Log in here

1/2 Inch Spacer for 1200 lb. Lock

Item#:
AM6300
You must be logged in to order this item. Log in here

Slim-Line Electromagnetic Lock for Narrow Profile Door Frame

The EM-Mag1500 compact electromechanical lock is designed for outswinging doors and small enclosures. The RCI EM-Mag1500 is significantly smaller than standard electromagnetic locks. This electromechanical solution includes a bi-color light panel for indicating lock status, an early warning alarm, and an anti-tamper security plate.

  • Energy: 240mA Field-Selectable 12/24VDC (At 12VDC, 120mA at 24VDC)
  • Strength: 1,500lbf Holding Force
  • Mode: Fail-Safe
  • Monitor: Lock & Door Status Sensors
  • Warranty: 3 Year Limited Warranty

Item#:
EM-MAG1500
You must be logged in to order this item. Log in here

Single-Door Electromagnetic Lock with 600LB Holding Force, 12 or 24 VDC

  • Anodized aluminum housing (US 28)
  • 12 or 24 VDC (selectable)
  • No residual magnetism
  • Adjustable mounting bracket
  • MOV surge protection
  • Complete mounting hardware for typical installations
  • "L" bracket and "Z" brackets available for easy mounting
  • Detachable face plate
  • UL and ULC listed
  • CE listed
  • RoHS compliant

Item#:
E-941SA-600
You must be logged in to order this item. Log in here

Blue Pull Station 1 SPST N/C U niversal w/ 5 Labels

Item#:
CM-701U
You must be logged in to order this item. Log in here
|◀ ◀ 265 - 276 of 23802 ▶ ▶|
View:
(Denotes required field.)